Get a Quote on WhatsApp
Open Monday–Sunday, 7:00 AM – 9:00 PM
03-8084 0160
Not cooling, leaking water, tripping the breaker, or dead on the remote? We diagnose the root cause first and quote the fix on WhatsApp before any paid work starts. across Kuala Lumpur.
Aircond repair is a diagnose-and-fix service: the fault is traced to its root cause — the PCB, a capacitor, the fan motor, a sensor, drainage, refrigerant or the compressor — and the fix is quoted before any paid work goes ahead. If a part has to be ordered, that is quoted too. And if a unit is genuinely beyond economical repair, we say so rather than sell you a fix that will not last.
Every repair we do in Kuala Lumpur follows the same six-step workflow, residential or commercial. You approve the cost before any paid work begins.
You WhatsApp us what’s wrong — not cooling, leaking, tripping, no power. We ask the unit’s HP and age so the technician arrives prepared.
Technician tests the PCB, capacitor, fan motor, sensors, gas pressure, and drainage to isolate the actual root cause — not just the symptom.
You get a written WhatsApp quote with the exact fix, parts, labour, and total. No paid work proceeds until you approve it.
Faulty PCB, capacitor, fan motor, sensor, or drain line repaired or replaced on the spot. Parts to order are quoted with an ETA.
Unit powered up and checked. Outlet temperature, drainage, and breaker load checked to confirm the fault is gone.
What was found and what was done is confirmed to you on WhatsApp.
If your unit is doing any of these, it’s a fault — not something a routine service will fix. Get a diagnostic.
Fan blows but the air isn’t cold. Usually low refrigerant from a leak, a weak compressor, or a faulty thermistor — all need diagnosing, not a top-up guess.
The aircond trips your MCB when it starts or after a few minutes. Often a shorted compressor, failed capacitor, or wiring fault — a safety issue we test before touching anything.
Dripping onto the wall or floor. Blocked drain line, cracked drain pan, or a frozen coil from a refrigerant fault — we find which before quoting.
Unit won’t switch on, or the remote does nothing. Could be the PCB, receiver, power supply, or just the remote. The diagnostic pins it down so you don’t overpay.
Compressor kicks in then cuts out repeatedly, never holding the set temperature. Points to a capacitor, sensor, or pressure-switch fault that’s straining the unit.
Rattling, grinding, or a fan that won’t spin. Usually a seized fan motor or worn bearing — left alone it can take out the PCB, so it’s worth diagnosing early.
Whether it’s a condo in Mont Kiara or a cafe in Bangsar, the diagnose-first approach is the same — only the unit count and downtime urgency change.
Apartments, condos, and landed homes. Bedroom or living-area units that stopped cooling, leak, or trip the breaker — diagnosed and fixed with the cost approved before any paid work.
F&B outlets, retail, clinics, offices. A dead unit means lost trade, so we diagnose the fault and tell you straight away what it needs. Multi-unit faults handled in one trip.
Tell us what the unit is doing — not cooling, leaking, tripping, no power — plus the HP and rough age. A short video of the fault helps the technician arrive prepared.
We confirm a slot and the diagnostic fee. The diagnostic identifies the root cause — you’re never charged for a repair before we know what’s actually wrong.
We agree a visit time that suits you. We send arrival ETA on the morning of the visit.
Root cause found, fix quoted in writing on WhatsApp, and — once you approve — repaired on the spot. Ordered parts come with an ETA.
The unit is run and checked to confirm the fault is gone. If the same fault returns, we come back free.
Every job starts with a diagnostic. The technician finds the root cause first, then quotes the exact fix on WhatsApp before doing any paid repair work — so you approve the cost upfront. If a part needs to be ordered, we quote it with an ETA. No work proceeds without your sign-off.
Between 30 minutes and 3 hours depending on the fault. A capacitor or remote-sensor swap is quick; a fan motor replacement or PCB-level repair takes longer. — only faults needing an ordered part require a second trip.
PCB and control-board faults, capacitor failure, seized fan motors, water leaking from the indoor unit, compressor short-cycling, thermistor and sensor errors, no-power and remote issues, breakers that trip when the aircond runs, and units that run but won’t cool. We diagnose the root cause before quoting any fix.
We tell you straight. If a unit is beyond economical repair — for example a dead compressor on an old unit where the repair costs more than a replacement — we say so and won’t upsell a doomed fix. You only pay the diagnostic and decide from there. We cover areas across Kuala Lumpur.
R22, R32, or R410A topped to OEM pressure with a leak test included. For units blowing warm air after a diagnostic.
Learn more →Full strip-down restoration for tired units — when a single repair isn’t enough but the unit is still worth saving.
Learn more →Deep dismantle clean of the evaporator coil. Often the real fix when weak cooling is down to a fouled coil, not a fault.
Learn more →A look at recent residential and commercial jobs handled by our in-house team in KL.
WhatsApp us the symptom and we will arrange the diagnostic. Root cause found and quoted before any paid work.
Get a Free Quote on WhatsApp