The most thorough non-replacement service there is — full dismantle, deep coil wash, fan bearing and capacitor replacement, drainage rebuild, electrical re-tightening and gas restore. The right call when the compressor is healthy but the unit is noisy, weak, or leaking. Cheaper than a new unit, for residential and commercial across all 24 KL districts.
An aircond overhaul is the most thorough non-replacement service we offer. We fully dismantle the unit, deep chemical wash the coil, replace the fan bearing and blower motor capacitor, rebuild the drainage system, re-tighten the electrical terminals, check the swing motor and sensors, and restore gas pressure. It's the right call when the compressor is still healthy but airflow and cooling have badly degraded, the unit is noisy or vibrating, or several small faults have stacked up. Done in about 3 hours per unit — and far cheaper than buying new.
Every overhaul we do in Kuala Lumpur follows the same six-stage scope, residential or commercial. Photo evidence at each stage, sent on WhatsApp.
Indoor casing, filter, blower fan, swing flap, PCB cover, drain pan and motor assembly all removed. Every component inspected before work begins.
Evaporator coil and blower deep-soaked in biodegradable solvent, then pressure-flushed until runoff runs clear. Restores airflow the same way a standalone chemical wash does.
Worn blower fan bearing replaced to kill the rattle and vibration; blower motor capacitor swapped so the fan spins back up to full speed instead of stalling or running weak.
Drain pan, channel and full drain line cleared and rebuilt — not just flushed. Stops the chronic dripping and clogging that recur on units that only ever get a quick service.
Terminal block and connections re-tightened to stop heat-soaked loose contacts; swing motor and temperature sensors tested and recalibrated so the unit reads and cycles correctly.
Refrigerant lines leak-checked and gas pressure restored to OEM spec. Unit reassembled, run for 15 minutes, and outlet temperature measured pre and post on the job sheet.
If two or more of these apply, a chemical wash or general service alone won't fix it — the unit needs parts, drainage and electrical work too.
A worn fan bearing is grinding. No amount of cleaning fixes this — the bearing has to be replaced, which is part of the overhaul, not a wash.
If you washed the coil and the room is still warm, the bottleneck has moved past the coil — usually a weak blower (capacitor) or low gas. An overhaul addresses all of it at once.
If the unit drips again within weeks of a flush, the drain pan and line need rebuilding, not flushing. Overhaul rebuilds the whole drainage path.
Weak airflow, a stuck swing flap, a faint burning smell, slow start-up — when three or four niggles pile on one unit, an overhaul fixes them in one 3-hour visit instead of repeat call-outs.
The outdoor compressor still kicks in and holds, but the unit no longer cools like it used to. That's the ideal overhaul case — healthy compressor, everything else restored.
Before you spend on a replacement, let us inspect it. If the compressor is healthy, an overhaul restores near-original performance for a fraction of the price of a new aircond plus install.
Whether it's a 6-year-old bedroom unit in Cheras or a hardworking cassette in a Bangsar cafe, the scope is the same — only the unit count and run-hours change.
Apartments, condos and landed homes with units 5–10 years old that still have a good compressor but have gone noisy, weak or drippy. An overhaul buys years more life and saves the cost of a full replacement plus re-install.
F&B outlets, retail, clinics and offices running long hours where downtime costs money. Overhauling a fleet of healthy-compressor units is far cheaper than replacing them and keeps the floor cool through peak trade.
Send a photo of each aircond, the HP if you know it, and a note on the symptoms — noisy, weak, dripping. One message is enough to start.
Quote covers parts, labour and total time for the overhaul. No verbal estimates — sent on WhatsApp so it stays in your chat history.
The technician confirms the compressor is healthy before starting. If it's dead or the unit's too old, we'll tell you straight to replace it instead of overhauling — no overhaul that won't pay off.
The full six-stage scope above — dismantle, coil wash, parts, drainage rebuild, electrical, gas restore. Photo evidence at each stage on WhatsApp; outlet temperature logged pre and post.
3-month labour warranty issued on WhatsApp. Same-day dispatch across all 24 KL districts if your job is confirmed before 4 PM.
The most thorough non-replacement service we offer. We fully dismantle the unit, deep chemical wash the coil, replace the fan bearing and blower motor capacitor, rebuild the drainage system, re-tighten electrical terminals, check the swing motor and sensors, and restore gas pressure. It's the right call when the compressor is still healthy but airflow and cooling have badly degraded — restoring near-original performance for far less than a new unit. Takes about 3 hours per unit.
A chemical wash only cleans the coil — about 90 minutes — and fixes weak cooling caused by a dirty coil. A general service only does the filter and blower. An overhaul does all of that plus replaces worn parts (fan bearing, capacitor), rebuilds drainage, and re-tightens electrical — a full restoration when several faults have stacked up. Replacement is only worth it when the compressor is dead or the unit is too old; if the compressor is healthy, an overhaul costs less and restores near-original performance.
About 3 hours per unit, because an overhaul covers cleaning, parts replacement, drainage rebuild and electrical work in one visit. Same-day dispatch across all 24 KL districts if the job is confirmed before 4 PM; otherwise next-day. Multi-unit jobs are staffed with a small team so they finish in one trip.
If the compressor is still healthy, an overhaul is almost always cheaper than a new unit and restores near-original cooling, airflow and quiet running. We're honest about it: if your inspection shows a dead compressor or a unit too old to justify the work, we'll tell you to replace it instead of selling you an overhaul that won't pay off. Overhauls come with a 3-month labour warranty.
Coil-clean only — dismantle and deep solvent wash of the evaporator coil. The right fix when weak cooling is purely a dirty-coil problem.
Learn more →Fault-finding for a single problem — no cooling, error code, water leak or tripping breaker — fixed at the source.
Learn more →Wall-mounted, cassette or ceiling-concealed split installations across all 24 KL districts — for when replacement is the right call.
Learn more →A look at recent residential and commercial jobs handled by our in-house team in KL.
Send a unit photo on WhatsApp — written quote in under 5 minutes, honest inspection first, and same-day dispatch for jobs confirmed before 4 PM.
Get a Free Quote on WhatsApp