Get a Quote on WhatsApp
Open Monday–Sunday, 7:00 AM – 9:00 PM
03-8084 0160
Deep dismantle clean of the indoor evaporator coil and blower using biodegradable solvent — the only way to restore cooling efficiency on a unit that’s been running for 18–24 months. For residential and commercial across Kuala Lumpur.
An aircond chemical wash is a deeper clean than a standard service. The indoor unit is opened up and chemical solution is used to reach build-up on the coil and blower that a normal clean cannot get to — the compacted dirt and mould that cause musty smells and weak airflow. How often it is worth doing depends on how hard the unit works and the condition it is in, which is why we assess the unit before recommending it.
Every chemical wash we do in Kuala Lumpur follows the same six-step scope, residential or commercial. Photo evidence at each stage, sent on WhatsApp.
Mains breaker cut, condenser fan locked, drainage rerouted to a containment tray. Site protection sheet over flooring and walls.
Indoor unit casing, filter, blower fan, swing flap, and PCB cover removed. Drain pan unclipped and inspected for damage.
Coil and blower deep-soaked in evaporator-safe solvent. Loosens 18+ months of compacted dust, bacteria, and biofilm.
Coil and blower flushed with low-pressure water until runoff is clear. Drain channels and pan flushed separately.
Gas pressure checked at the service port; refrigerant lines inspected for leaks before reassembly.
Unit reassembled, powered up and checked. Outlet temperature measured before and after, recorded on the job sheet.
If any two of these apply to your unit, a general service won’t fix it — the coil itself needs to come out.
Mould has reached the visible surface, meaning the evaporator coil behind it is much worse. Filter clean alone won’t reach it.
Bacteria and biofilm built up on the cooling coil. The smell hits hardest in the first 30 seconds after the compressor kicks in.
If a general service two months ago helped briefly but the room is warm again, the coil itself is the bottleneck — not the filter.
Drain pan clogged with accumulated biofilm. Chemical wash flushes the pan and drain line at the same time as the coil clean.
Dirty coil makes the compressor work harder for the same cooling.
Even if everything seems fine, KL humidity and urban dust make 18–24 months the practical limit for residential units. F&B should chemical wash every 12 months.
Whether it’s an apartment in Mont Kiara or a cafe in Bangsar, the scope is the same — only the schedule and unit count change.
Apartments, condos, and landed homes. Most KL households book chemical wash every 18–24 months — typically two units per visit (master bedroom + living area).
F&B outlets, retail, clinics, offices. Higher run hours and exposure to cooking grease or foot traffic mean chemical wash every 12 months — often staffed with two technicians for parallel coverage.
Send a photo of each aircond, the HP if you know it, and the room. One message is enough — we’ll come back with follow-up questions if needed.
Quote covers parts, labour, and total time. No verbal estimates. Quote sent on WhatsApp so it stays in your chat history.
We agree a visit time that suits you. We send arrival ETA on the morning of the visit.
Six-step scope above. Photo evidence at each stage sent on WhatsApp. Outlet temperature measured pre and post, logged on job sheet.
The completed work is confirmed to you on WhatsApp. A reminder later on when the next chemical wash is due.
A deep dismantle clean of the indoor unit’s evaporator coil and blower using biodegradable solvent. It removes dirt, mould, and bacteria that a regular service can’t reach, and reaches build-up a regular service cannot. Recommended every 18–24 months for residential and every 12 months for F&B and high-traffic commercial.
The most common unit size in KL apartments is a 1.5HP wall-mounted split. Larger 2.5HP+ units take utes. Multi-unit jobs are scheduled with a small team so the work runs in parallel.
How often depends on how hard the unit works — a home bedroom unit and an F&B air handler are not on the same cycle. KL’s humidity and urban dust speed up coil fouling, so units in KLCC, Mont Kiara, and Bangsar usually need it within the shorter end of that range.
A general service cleans the filter, blower and drainage. A chemical wash dismantles the indoor unit and deep-cleans the evaporator coil with solvent. Chemical wash is needed less often but does much more.
Wall-mounted, cassette, or ceiling-concealed split installations across Kuala Lumpur.
Learn more →PCB faults, capacitor failure, fan motor seize, water leakage.
Learn more →R22, R32, or R410A topped to OEM pressure with a leak test included. For units blowing warm air.
Learn more →A look at recent residential and commercial jobs handled by our in-house team in KL.
Send a unit photo on WhatsApp and we will come back with a written quote.
Get a Free Quote on WhatsApp